Features:
Rated voltage: DC 12V
Rated power: 60 W
Maximum pressure: Max. 0.8 MPA
Maximum flow rate: 5L/min
Pump diameter: approx. 4.8cm/1.89 ”
Length: approx. 14.5cm/5.7″
Outlet pipe size (Dia. * L): approx. 11mm * 140cm/0.43 “* 55”
Inlet Pipe Diameter: Approx. 8 mm and 6 mm/0.31 “and 0.24″
Length of inlet pipe: approx. 100 cm/39.37 ”
Cable length: approx. 30 cm/11.8″
Length of clips: approx. 8 cm/3.15 ”
Main color: black
How to use:
1. Start running the engine of the car for a while, when the oil temperature becomes about 50 degrees, start pumping the oil.
2. Connect the pump to the mains, run it for a while and observe if the inlet and outlet are normal.
3. Open the filler cap, take out the dipstick, force the tube into the bottom of the joint, until the tube does not move; then put the tube in ” inlet of the dipstick at the end (the tube in the bottom of the tank, the lower concave place, in order to completely pump the oil); as no oil or very slow or intermittent pumping, this is usually caused by pipes and loose fittings. You need to reinstall the pipes and fittings.)
4. After pumping the oil, remove the tube, and then run the pump for a while, pump the remaining oil inside the clean pump or pump water for a while until the pump head is clean.
Package Included:
1 x oil pump
1 x 11mm outlet pipe
1 x 8mm inlet pipe
1 x 6mm inlet pipe
2 x clips