If your Wirquin Jolly fill or Topy inlet valve won’t shut off properly it could very well be that the diaphragm washer inside of the valve needs to be replaced. Over time as the valve is continuously opening and closing, small tears can start to form in the diaphragm washer, in turn the diaphragm washer will no longer give a good seal. And debris in the water supply (which can be commonly caused by nearby work being carried out on the water supply) can also contribute overtime to this washer being worn. Many make the mistake of purchasing a full replacement inlet valve at the first sign of any issue, replacing just this washer may save you a lot time and money in the long-term. We advise purchasing a couple of these washers at a time so you’ve got one readily available in the event that the washer fails again in future.
Part Number:- 10717797
Product Dimensions:- 3.2 x 3.2 x 1 cm; 20 g
Item model number:- 10717797
Colour:- Multi-colour
Material:- Plastic, Rubber
Item Package Quantity:- 1
Number of Pieces:- 1
Measurement System:- Metric
Included Components:- 1 x Wirquin Jollyfill & Topy Inlet Float Valve Diaphragm Washer 10717797
Batteries included?:- No
Batteries Required?:- No
Item Weight:- 20 g
Date First Available:- 30 April 2014
Material:- Plastic, Rubber
Brand:- Wirquin
Item dimensions L x W x H:- 32 x 32 x 10 millimetres
Exterior finish:- Plastic,Rubber
Inlet connection type:- Barb
Valve type:- Float Valve
Manufacturer:- Wirquin