ater retention system for any place water control is a problem， angled shower pan\base or barrier free, roll-in ，zero transition showerswhere water splashes here and there. Environmentally friendly silicone material，soft for protection，easy to install for professionals or housewife，our waterproof shower threshold would do a good job in preventing costly floor damage from spillovers. Ideal as a showerwater dam barrier，water guard，water stopper，splash guard, it would be your first and perfect choice.Installation steps and attentions：(1) Please completely clean the surface and allow to dry. That is very important.(2) Determine the position of the water retaining strip and mark it with a pen on the ground.(3) Cut the water dam to length with a hacksaw.(4) Peel off the pre-applied adhesive tape and put in place. Heat the gum by hair dryer for better stickiness when it’s cold.(5) Caulk any edge seals and clean up excess silicone leaving a smooth caulk line.(6) Allow to dry and no contact with water in at least 24 hours.
Adoture Collapsible Shower Water Guard Shower Splash Guard Water Dam Retention DIY System Bathtub Splash Guard, Keeps Water Inside Threshold(1 M, Washing Table-White)
$29.99
- Adoture shower water barrier, a wet room floor barrier to keep water inside the threshold, achieve dry and wet separation in your kitchen/bathroom. Suitable for kitchen, bathroom, washing table, table top and other areas where water needs to be contained.
- Safety MaterialEnvironmentally friendly silicone material, soft and easy to clean. It will not hurt the soles of your feet when you step on it.
- DIYOur shower water barrier support the cutting length of the shower barrier freely. It is recommended to install only in a straight line, can not be bent. Please cut the water retaining tape at the corner at 45 degree angle and then connect it.
- Installation NoteEach water barrier comes with installation instructions by Adoture. Please check the installation tutorial and installation video. Requires glass glue yourself, it is necessary to fill the places where the two ends of the shower splash guard are in contact with the wall with glass glue to reinforce the seal. Dry for at least 24 hours without exposure to water.
- Multiple StylesClassic Style: 3cm/1.18 W x 4.6cm/1.81 H; Wave Style: 3cm/1.18 W x 4.5cm/1.77 H; T type: 1.5cm/0.59 W x 3cm/1.18 H; L type: 2cm/0.78 W x 1.2cm/0.47 H; Magnetic Style: 1.5cm/0.59 W x 2cm/0.78 H; Stick Type: 3.4cm/1.34 W x 4.7cm/1.85 H. Adoture provides a variety of styles/size of silicone wet room floor barrier. If you have any questions or need longer length, please feel free to consult Adoture.
In stock