Ansonic SA 434-1mini / SA 434-1mini/M/SA 434-2mini/M/SA 434-2midi compatible hand transmitter / 4-channel clone remote control 433.92 MHz fixed code copier

This is a high quality clone remote control that will clone your Ansonic SA 434-1mini / SA 434-1mini/M / SA 434-2mini/M / SA 434-2midi 433.92MHz fixed code remote controls. With this remote control clone you can clone all 433.92MHz fixed code key fobs. How to clone your remote control with a simple programming videos: https://www.youtube.com/watch?v=cysYPSMgPXY or https://www.youtube.com/watch?v=oX4FNLXNXpQ . Follow these simple steps to program your remote control. You need to clear the remote first: 1) Press and hold buttons 1 and 2 at the same time – the LED flashes 3 times 2) Press and hold the button 1 and release the button 2 3 times, the LED will flash continuously (this means that the remote control is cleared). Next, you need to clone your original remote: 1) Place both remote controls (ORIGINAL and CLONE) in the “back to back (II)” or “side by side” position. Make sure they have direct contact and touch. 2) Press and hold 1 button on your original remote and 1 button on your clone remote. Press and hold the button until the LED lights up: 2 flashes – 3 times – continuous light = successful cloning only when the light is on permanently. If for any reason the clone flashes no further than 2, this means that the signal does not pass through, please slide the remote slowly up and down until you reach the point where it will go through. Note: You do not need access to your control board or receiver! If you want to increase the range of the remote control reception to 150-200 metres, you can connect this antenna: https://www.store.de/dp/B0BWFH3TGT If you need car sun visor clip holder for remote controls, you can buy it here: https://www.store.de/dp/B07FVW7F59