BL TOUCH1. An additional power supply may be needed in case your board does not supply enough current at 5V.2. Set Zmin pull-up on your firmware when using Logic Free (In most cases, it is already set up).3. If push-pin deploy fails, turn the core by up to 180 degrees with an Allen-key so that the core is further inside the casing.4. Depending on your type of 3D printer, you may need to remove or add some parts to the controller board.5. In principle, a controller board with a large capacitor in the end stop input circuit is not supported. (You may need to remove such a capacitor from your board)6. If noise, etc. interference is expected, you should use an anti-interference extension cable (Shielded or Twisted Cable).7. BIGTREETECH IS ONE OF THE DISTRIBUTORS OF ANTCLATS-BL TOUCH IN CHINABLTOUCH Specification1. Voltage / Current: 4.8 ~ 5.1 V2. Current: 15mA. Maximum (Peak): 300mA3. Z Probe Output: Logic Free (Open Drain: default) or 5V logic. Open Drain VDS / ID: Max VDS = 5V / Max ID = 300mA4. PCB / Soldering: OSP / Lead Free5. Cable Length: 150±5 mm (for retail)6. Weight: 0.35oz (10g)7. Wiring: 3Pin: Brown (GND), Red (+5V); Orange (control signal). 2Pin: Black (GND) White (Zmin)8. Case & Push-pin: Polycarbonate (PC)9. Electronic devices can be damaged or even destroyed if connected to the wrong side polarity.
BIGTREETECH SKR Mini E3 V2.0 Control Board 32Bit 3D Printer Parts
$174.99
- 1) If the red status indicator on the board does not work: When the firmware update operation is completed, the indicator will stop flashing. If the indicator does not flash during the firmware update process, it may be that the firmware name in the SD card is capitalized, please change it to Lower case; or the file system of the SD card is wrongly selected, please set it to FAT32; or there may be a problem with the card slot or chip of the motherboard, please consult us and help you.
- 2) If the stepper motor is overheated: the drive current may be set too large, please try to reduce the motor current; the drive may not have a heat sink installed, or the heat dissipation work has not been completed, please check the ventilation environment where the printer is located. If the stepper motor does not respond: please connect the main board to the 12/24V power supply; the firmware may be set incorrectly, please update the pre-compiled firmware on our official website.
- 3) Board does light up, but no power to the fans? The fan of motherboard is a CNC fan. You need to set the fan speed on the display screen for the fan to work normally; check the fan wiring, some fan wiring and the motherboard fan port pin sequence is not the same; if the above content is correct, please contact us, we can identify the problem, and then carry out the warranty service.
- 4) Got a blank blue screen? The main control chip may be lacks firmware, so the display will be blank. Please try to update the pre-compiled firmware on our official website; if the firmware cannot be updated, please contact us and we will provide you with warranty service; or try to replace the EXP cable, it may be a cable problem.
- 5) When the heated bed is enabled, the temperature readings bounce around? The R&D department has solved this problem, if the problem still occurs, please consult us and help you.
In stock
Additional information
Weight | 0.118 kg |
---|---|
brand | BIGTREETECH |
dimensions | 13.89 x 12.5 x 3.4 cm; 118 Grams |