Manufacturer reference: 939.160.11. – A wide range of media and audio formats are supported including DivX, Xvid, XML, XML, XML, XML, XML, XML, XML, XML, TXT and XML, XML, TXT and XML, XML, TXT and CSV. CMT concave radio strawberries give them a vast array of profiles, ideal for boats and visible furniture edges. When you lower the tool so that you can discover the straight part of the cut: it allows you to add a decorative detail to the edges of tables, shelves and crossbars. Take two consecutive strokes (turn the wood for the second pass) and then you can immediately perform the double radio edge without having to buy another strawberry to round. The 739-839-939 concave radio burrs use a smaller guide bearing than the concave radius strawberries 738-838-938, so along the lower part of the cut is obtained a further slot. To convert your concave radio straw with slot into a concave radio (and vice versa), it is enough to change the bearing. All concave radius burrs (except spokes 28.6 mm (1-1/8″) and 31.7 mm (1-1/4″) that have a 19 mm (3/4″) bearing diameter 12.7 mm (1/2″). Concave radio burrs with slot have a 9.5mm (3/8″) bearing CMT offers them to choose between fifteen radio measurements, most of the same with five different handles. Each strawberry is equipped with micro-grain tungsten carbide segments. It is also noted that we offer these spokes of 1.6mm (1/16″) and 3.2mm (1/8″). Suggestion: Use our burr with radius 1.6mm (1/16″) for laminated edge terminations. By correcting the height of the cut it will save the time required for the operation of the sanding normally needed after using a normal straw to remelt. Safety recommendations: pay special attention during the use of a strawberry with a large profile, and do not hurt the work. Milling small pieces on the work table
