Adhesive-Sealant DR.Boat is a composition based on polyurethane for the repair and sealing of punctures or cuts in inflatable products made of PVC fabric and rubberized fabric without the use of trays.
AREAS OF APPLICATION. Repair and sealing of punctures and cuts in inflatable products made of PVC, PU and rubberized fabrics. Does not require the use of trays or other overlaid elements. It is recommended for the repair of inflatable boats, mattresses, water attractions, trampolines, and swimming pools, as well as frame products made of PVC fabric (awnings, tents). It can be used in stationary and matching conditions.
PROPERTIES. – Resistance to hydrolysis (water resistance) in salt and fresh water. – High strength and heat resistance. – Good plasticity, including at low temperatures.
INSTRUCTIONS FOR USE.
Repair of products made of Rubberized Fabric, PVC or PU fabric and PVC film.
Place around the damage (puncture or cut) – preferably at least 20 mm in each direction – clean from dirt and dust and wipe with a swab dipped in a solvent to remove grease. The solvent will evaporate (this takes 3 – 10 minutes depending on the ambient temperature). Large cuts longer than 3 cm must first be fastened, sewing the place cut with thread and needle. PVC film is not necessary to stitch. The place of damage must be fixed from the movement of the edges of the puncture or cut by any improvised means. Open the can with glue sealant and apply a thick layer to the damaged site, grasping the areas 10 – 15 mm around the damage. After 15 – 30 minutes (depending on the ambient temperature), re-apply a thick layer of glue sealant. After 5-7 hours you can remove the fixation and the product can be used. Full strength comes in 24 hours.