roduct parameters ———-
????Water inlet valve
Main body material: ABS thickened plastic
Height adjustment: 19-33㎝
Water inlet connection: 4 points thread (2㎝)
Applicable height of water tank: more than 19㎝
????Drain valve
Body material: ABS plastic
Diameter of drainage port: 6.2㎝
Seal diameter: 8.5㎝
Main body height: 20.5㎝
Joint diameter：6.2-7㎝
Applicable water tank height: 20-25㎝
????Water tank button
Main body material: ABS plastic
Button diameter：7㎝
Rod length: 9㎝ (can be cut)
Features
1. High quality ABS plastic and thickened stainless steel for corrosion resistance and long service life
2. Anti-syphon design, waterproof backflow, built-in density filter to prevent debris from entering
3. Internal and external sealing ring, double leakage prevention
Water inlet valve installation tutorial
1. Unscrew the nut under the black sealing washer and set aside
2. Adjust the water inlet valve float to the appropriate inlet height
3. Clean the area around the water tank seal before installation
4. Place in the correct position, do not tilt
5. Once in the correct position, screw on the fixing screws.
6. Finally, tighten the nut to complete the installation.
Drain valve installation tutorial
1. measure the height of the original part in the original tank, the height of 22-25cm can be installed
2. Measure the size of the installation hole, the diameter is about 6cm, then you can install it.
3. Rotate the upper body of the drain valve and disassemble it.
4. Tighten the screw in the middle of the drain valve base
5. Install the upper part of the drain valve and finish the installation