ELCA ASTER2 / ASTER4 / E1001 E1002 E1000 / Gemini E1003 E1004 / Aster E800 / VIGRO / E702 / E702R / E700R E701 Compatible Handheld Transmitter / 4-Clone Remote Control 33.92 MHz Fixed Code Copier

This is a high-quality clone remote control that will fit your ELCA ASTER2 / ASTER4 / ASTER E1001, E1002, E1000 / GEMINI E1003, E1004 / ASTER E800 / VIGRO / E702, E700R, E. 701, E, 70701R fixed code remote controls. With this remote control cloner you can clone all 433.92 MHz fixed code key fobs. How to clone your remote control, we will show you in these videos: https://www.youtube.com/watch?v=rfua7-VTJp4 or https://www.youtube.com/watch?v=-sDjb0XUl0Y Follow these simple steps to your remote control to program You need to delete the remote control first: 1) Press and hold the lock and unlock button at the same time (the LED flashes 3 times) 2) Press and hold the lock button, press the release button 3 times, the LED will flash continuously. Now the remote is clear and ready to clon. Next, you need to clone your original remote control: 1) Place both remotes (ORIGINAL and CLONE) in the “back to back (II)” or “side by side” position. Make sure they have direct contact and touch, press a little to make them touch more firmly. 2) Press and hold 1 button on your original remote and 1 button on your clone remote. Press and hold the button until the LED lights up: flash 2 times, flash 3 times, continuous light = successfully cloned, only when the light is on permanently. If for any reason the clone flashes no further than 2, this means that the signal does not go through, please slowly slide the remote up and down until you get the point where it will go through. Note: you do not need access to your control board or receiver! If you want to increase the range of the remote control reception to 150-200 metres, you can connect this antenna: https://www.store.de/dp/B0BWFH3TGT e/dp/B07FVW7F59