Equinox 800 – 600 – 11” Coil Yoke Stiffener and Repair – Black

2 In 1 – Stiffener and or Repair Yoke No need of any special longer bolt uses the standard bolt supplied as with your detector. Minelab Equinox 800 – 600 Coil Yoke Stiffener and Repair Yoke The NOX 600 and 800 coil yoke stiffeners will make your coils less prone to breaking by reinforcing the existing yoke plates. There are 3 versions available one for the 11- and 15-inch coil and one for the 6-inch coil. This version by extending over and down the sides of the coil main body greatly reduces the sideways load on the shaft mounting tabs. If your yoke tab breaks off, you can use this part to repair the coil using two cable ties to hold the yoke plate in position securely. This is for anyone who has a broken yoke already. It uses 2 cable ties to fix the repair block in place. To fit simply, disassemble the coil from the steam and put the repair block in place, and secure around the coil body with 2 X 5 mm cable ties. Reassemble the coil back onto the shaft placing the broken yoke tab in place to get the right spacing and you are done. A. Full span inner support for maximum rigidity that some other types do not provide. B. Direction to front of coil arrow for fitting correctly. C. Extra lateral side supports. D. Internal cable tie management with extended side grips to encapsulate the coil body and dissipate lateral loads. E. Recessed coil bolt protection allowing use of standard coil bolt. F. Extra wide strong coil lug supports. G. 8mm coil bolt hole size. H. Fully encapsulated coil mounting covers. NOTE: This does not fit the new style 700 or 900 coils only the original Minelab 11 and 15 coils.