GFA SKX1GS / SKX2GS / SKX4GS compatible handheld transmitter / 4-channel clone remote control 433.92 MHz fixed code copier device

This is a high quality clone remote control that will clone your GFA SKX1GS / SKX2GS / SKX4GS 433.92MHz fixed code remote controls. With this remote control clone, you can clone all 433.92 MHz fixed code key fobs. How to clone your remote with a simple programming videos: https://www.youtube.com/watch?v=cysYPSMgPXY or https://www.youtube.com/watch?v=oX4FNLXNXpQ . Follow these simple steps to program your remote control. You need to delete the remote control first: 1) Press and hold the buttons 1 and 2 at the same time – the LED flashes 3 times 2) Press and hold the button 1 and release the button 2 3 times, the LED will now flash continuously (that means that the remote is deleted). Next, you need to clone your original remote control: 1) Place both remotes (ORIGINAL and CLONE) in the “back to back (II)” or “side by side” position. Make sure they have direct contact and touch. 2) Press and hold 1 button on your original remote and 1 button on your clone remote. Press and hold the button until the LED lights up: flash 2 times, flash 3 times, continuous light = successful cloning, only when the light is on permanently. If for any reason the clone flashes no further than 2, this means that the signal does not go through, please slowly slide the remote up and down until you get the point where it will go through. Note: you do not need access to your control board or receiver! If you want to increase the range of the remote control reception to 150-200 metres, you can connect this antenna: https://www.store.de/dp/B0BWFH3TGT. If you need car sun visor clip holder for remote controls, you can buy it here. https://https://www.store.de/dp/B07FVW7F59