HERUNNA Wooden Bracelet Maker, Speed Steel Drill Round Bracelet Drills Bit Household Wood Tools for Making Personalized Wooden Bracelet and Jewelry

Operation steps: 1. Before starting drilling, center it first, use a twist drill to drill holes on the board to be drilled, drill Wear;2. Install the knife, install it on the bench drill, start the bench drill, and see if the cutter head swings. After confirming, drill down with the drill holes on the wooden board. It’s better to move forward slowly and feel that there is no vibration in front of the drill bit). After half of the belt drill, turn the wood upside down and align it with the drill hole to drill the other side (repeat the previous operation), and the blank of one finger will come out;3. Grinding, I use a hexagonal handle to polish the rod, use a piece of wood that can be inserted into the wrench in front, knock the polishing rod in, and then put the wrench on the sleeve, rotate on the machine, use sandpaper 400 mesh 800 mesh 1500 mesh 3000 mesh 7000 mesh polished.4. Finally, it is enough to polish with cotton cloth, and the inside is polished with a hand holding a finger, so that one finger becomess: 1. Use a twist drill to make holes in the fixed wood.2. In this case, the knife cannot be returned as long as the knife is lowered.3. The wood will look a bit soft, and it needs harder wood.4. The jig under the wood needs to be fixed well, and it cannot be shaken back and forth.5. Both sides need to drill to make the finger pullage IncludingPackage included:1 x Handle5 x Blades5 x Drill Bits1 x Wrench