Humbrol AQ0010 Enamel Tinlet No 10 Service Brown – Gloss

Always stir the paint to ensure a uniform mix throughout the container. We recommend stirring in a figure-of-eight motion for a minimum of 30 seconds or longer. You can never stir too much. Some parts of your model kits are best painted before being glued together. Always scrape any paint from the surfaces to be glued to ensure a good bond; the glue’s effectiveness is much reduced on a painted surface area. Always apply paint sparingly on important detail so as not to obscure it, or thin the paint down first before applying. When applying several coats of paint always make sure that the previous coats have thoroughly dried, or a fine ‘wrinkling’ effect can occur. When painting large areas using a brush, it is better to use a larger brush to eliminate any brush strokes. After using your tinlet of paint always clean around the neck of the container before putting the lid back on. This will give a better seal between the lid and tin. If you are painting using any technique, product or material for the first time, we always recommend experimenting on either a sample piece or a small non-visible area of your item before painting the whole area. Please Note: All Humbrol products must be used at room temperature for them to mix and work correctly. Usage A solvent-based, fast-dry paint developed for use on plastic model kits but which can also be used on other substrates. Matt, Satin, Gloss, Metallic, Metalcote and Clear finishes are available (finish varies by colour) Substrate A wide range of surfaces including most plastics, wood, glass, ceramics, metal, cardboard, sealed plaster, sealed hardboard and more (always try on a small test area to check suitability) Application Brush straight from the tin. Airbrush with a suitable thinner such as Humbrol Enamel Thinners. Two thin coats are preferable to one thick coat. The usual thinning ratio is 2 parts paint to 1 part thinner. Note that Metalcote colours are designed to be polished when fully dry. Drying time Gloss: 1-2 hours Matt & Satin: 20-40 mins touch dry, up to 24 hours for hard dry Metallics: hard dry in approx. 10 days. Drying times will vary according to ambient temperature and humidity. Recoat: 6 hours minimum (preferably overnight) How to clean: Brushes: use Humbrol Enamel Thinners Airbrush: flush thoroughly using Humbrol Enamel Thinners. Product is permanent once dry.
Flammable. Repeated exposure may cause skin dryness or cracking. Vapour may cause drowsiness and dizziness. Contains cobalt octoate,methyl ethyl ketoxime. May produce an allergic reaction. Keep out of reach of children. Keep away from sources of ignition. No smoking. Use under adult supervision. If swallowed, wash mouth out with water. Do not induce vomiting., keep at rest and obtain medical attention