ieron Network Cable Tester, Wire Tracker Network Tester Kit to Test Circuit Continuity for Network, RJ11 Plug&Alligator Clips, Telephone Line, Cable Finder Tone Generator Probe Tracer

Package List:
1 ieron Cable tracker sender emitter with 2 alligator clips & RJ-11 plug
1 ieron Cable tracker receiver
1 ieron user manual
1 ieron tool bag
Packaging size: 255 * 120 * 36mm
Packaging weight about: 0.26KG (not including battery!!!)
Item Descriptions:
-The cable tracker is designed to identify and trace wires or cables within a group simply by attaching the sender to the cable at one end and then touching the cables at the other end with the receiver to confirm which is the correct cable, without damaging the insulation.
-For telephone lines, it can identify some states in the line and can help to install, debug, and maintain the telephone line.
-Always turn off the power before using any mains cables.
-Signal Detector
Non-contact probe audibly identifies selected wire or cable.
Rotate the volume/sensitivity control on the probe for the appropriate level and sensitivity to identify and trace the wire.
-Signal Sender
Switch to Tone Mode and use only one alligator clip to Trace Wire.
Switch to Continuity Mode and use both alligator clips to check for continuity and short circuits.
-Alligator Clips
In Tone mode connect the red clip to the Wire you wish to trace and the black clip to the ground if possible.
In Continuity mode connect each clip to each end of the circuit cable. If the wire is short-circuited or broken the Red LED with light. You can then use Tone mode to trace the wire all the way to the break location.
-RJ-11 Plug
Use the RJ-11 plug to identify ring and tip telephone lines and test the line condition (clear, busy, ringing).