Specification: Configuration:CFG or UART Microsteps: Up to 1/256 MicroPlyer: 1/256 Logic Voltage VI0: 3-5V Motor Voltage : 5.5-36V Motor Phase Current: 1.2A RMS, 2.0A Peak
How to use: 1. Pay attention to the direction, specific reference to guide the use of instructions; 2. In the printer control board when used, please correspond to the breakdown table, through the socket under the jump line caps to select the subdivision mode; 3. The heat sink directly affixed to the IC, pay attention to the heat sink and pin spacing, or will be made the heatsink is connected with each pin to cause a short circuit.
Note: 1 measure the voltage at the middle end of Gnd and potentiometer. 2 measurement of voltage must not connect the motor, otherwise easy to burn drive. 3 measurement of voltage should be connected to the power supply, do not only connect USB power supply. 4. Please check the merchandise before use not insert incorrectly.5-term work will produce heat, you can do a good job of heat dissipation.6. If you have any questions, please contact us in time.
Package Included: 4*TMC2208 4* Heat Sink
KINGPRINT TMC2208 v3.0 Stepper Mute with Heat Sinks Driver Stepstick Mute Replacement A4988 Drv8825 for 3D Printer(Pack of 4 PCS)
£49.99
- TMC2208 is a super mute two-phase stepper motor drive chip, continuous drive current 1.4A, peak current 2 A, voltage range 4.75v-36v,256 subdivision.
- The flexible Microplyer interpolation unit can provide up to 256 subdivision, even in a system with limited pulse frequency, sine control can be perfectly realized.
- The high load driver does not lose its step, and the TMC2208 of the spreadcycle mode guarantees that the stepper motor will smooth over 0 o’clock without the dead-zone current.
- With standard Step/dir interface, it is simple and convenient to use.
- STEALTHCHOP2 Ultra Mute technology can drive motor work in the case of extreme mute, can realize the control motor sound under 10dB decibels, the noise is much lower than the traditional current control mode.
In stock
Additional information
| Weight | 0.03 kg |
|---|---|
| brand | Brand: KINGPRINT |