KUNCAN 2FT Motorcycle SAE to O Ring Terminal Harness Wire 2 Pin Lug Cable, Eyelet Terminal Harness Extension Charge Cord, Quick Disconnect SAE Connection Lead, 10A Fuse

Feature: Much better than having to find an allen wrench to open the battery door then try to clamp those alligator clips onto the battery. The length is perfect to hide the charging end behind the rear brake reservoir. These little ring terminal harnesses are super handy to have installed on your most charged devices. These are a must-have for old carbureted motorcycles, sticking them on my modern bikes. It is worth having one of these on every battery in your garagee is no need to lift the seat but still trickle charge, as you can leave it attached and tucked it in under the seat to charge battery with an accessory connector (and a USB charger) to recharge your devices, or run an air pump and easy to connect and disconnect, you can to install on your battery for quick connection to the battery maintainer is the best way to keep a battery charged on a car, or used it to keep the battery fully charged on the emergency generator Terminal to SAE : Molded 45P PVC Black Molded PE Transparent Female Bullet Terminal: 4.57mm Rec, Nickel Plated Brass Male Bullet Terminal: 4.57mm Pin, Nickel Plated Brass Ring Terminal : Molded PVC Black 45P Molded PE Black 45P Terminal: 8.4*13.8 R Type, Brass Fuse case : Molded PVC Black 45P Molded PE Transparent Car Fuse: 10A Terminal: 205 Female Type, Nickel Plated Brass Cable: SPT-2 16AWG/2C Red/Black Length: 2ft OD: 3.7*7.4mm Package: 1 pcs