Features of exceptional performance in comparison with other lacing Polyamide of alloys: Low elongation greater lineartragk raft node greater resistance the line STROFT LS was developed on the basis of a new alloy of polyamide. Tuning focuses on the reduction of the gauge at the same time ensure possible train festigkeiten. For This Is The keyboard LS (For Low Stretch) Features elongación. diagram?? Elongation For line STROFT LS (Lilac) shows a break (in case of load 100% Rope) of approximately 17%. This is significantly less as in the other laces of polyamide or also in lace fluorocarbono. also in the area of the anhiebdehnung (50% load) is LS with a gauge of wire of approximately: 9% have included. (only twisted rope of UHMWPE clearly a load elongation even smaller) in the area of the Fein drag (10% elongation rope approximately.) LS is also below the threshold of the other Polyamide laces, but slightly above fluorocarbono. are the values of resistance to traction (on average of all 10 mm diameter of between 0 and 0, 60 mm) the highest, until the date have been achieved in monofilen. This is suitable for both the train Festigkeiten with knots, as well as for the train Festigkeiten without nodos. in the area of the thinner diameter values are more similar to the GTM, but then Constantly In aumentando. the 33 0, 60 mm line STROFT LS contributes important, i.e., 0 kg, and if it can be taken to the lowest possible forces fiddling with maximum capacity Important and a little more rigidity in the purchase, well line STROFT LS is the first elección. the something greater rigidity, also a memory, slightly larger so that is also in the knot tie (according to the type of nodes) negative can make sentir. if is one of these nodes were linked not correctly?, May be a lightweight swirls? The cuerda. so in the practical use, as for example a hexagonal