Windhager Vole Traps, Super Strong, Adjusting Ring Vole Trap, Vole Control, Snap Trap, Set of 2 + 1 Stretcher, 05336

Effectively catch voles with the super strong trap. Voles are unwanted in the garden – they not only destroy the lawn, but can also ruin the vegetable harvest. With the proven super strong vole trap, you put an end to the whole. With this high quality and durable trap with extra strong spring, you can catch voles effectively and reliably. The trap triggers even at low pressure. After a successful catch, the vole trap can be reused directly with reusable positioning plate. Tip: how to find a vole outlet. Vole outlets, as well as mole runs, underground. However, they are usually not deeper than 5 cm and cause raised earth crusts and ground hills. The difference to a mole course is that the latter is usually lower and the ground hills are higher than voles. If you dig up a aisle, the vole will close it again in no time at all, while a mole would rather dig a new aisle underneath. This allows you to keep aisles of voles and moles apart. With the Windhager VOLE TRAP ACCESSORIES probe rod (item no. 05316) where gears are suspected poke into the earth. If there is no resistance to be noticed, there is probably one of the branched vole outlets. Mark these points with the Windhager marking flags (item no. 05317). If these hours later lie in the grass, the tunnel is frequented. Vole traps should be positioned exactly in these places. Vole trap set up voles have a very fine nose. To protect against odours, wear gloves. After a vole exit has been detected, the trap only needs to be placed. The super strong trap should be placed about 10 cm below the surface of the ground. After that, the hole must be covered again. For this purpose, for example, the previously removed grass scar or a bucket. In addition, the place where the trap is located can be marked with a marking flag (item no. 05317). This makes it easier to find the vole trap afterwards. Check the trap regularly. Remove the mouse after a successful catch, then the trap can be reset directly. The positioning plates are also reusable. Helpful accessories: probe stick with cutter (05316), marker flags (05317).