ALIRANTA GiBiDi AU01590 / AU1680 / AU1810 / AU1610 / Domino Compatible Remote Control / Rolling Code Handheld Transmitter 433.92 MHz

This remote control replacement is compatible with GIBIDI AU01590 / AU16080 / AU1680 wood / AU1810 / AU1600 / AU1610/ Domino. It pairs with your GIBIDI receiver unit just like the original remote control. Programming instructions with your receiver: 1. Open the housing of the radio receiver (at the end of the cable from the antenna) 2. Press the programming button on the radio receiver. Depending on the model, the key may be labeled as follows: ENR or Memo or Prog or Rec, etc. Note: Some receivers only need to press the programming button once and then release it. For others, you need to hold down the programming button. 3. A lamp on the receiver lights up or flashes. 4. Press and hold the button on your new remote for one second. 5. Release the button: Depending on the model, the light on the receiver will go out either immediately or within 10 seconds. 6. Check if your new remote is working properly. 7. Close the housing of the receiver receive programming instructions from an already programmed remote control. 1. Approach your engine so that you are a few meters away from it. 2. Press both buttons on the working remote control and hold them for about 5 seconds. Then let them go. 3. Press the button you want to use once on the new remote control. 4. Your new remote control is programmed. If you want to increase the range of the remote control reception to 150-200 metres, you can connect this antenna: s://.store.de/dp/B0BWFH3TGT If you need car sun visor clip holder for remote controls, you can buy it here: s://.store.de/dp/B07FVW7F59