Octopus Pro Motherboard features:1. Each motor drive individually selects the power supply, the motor power supply or the main power supply (heater power supply).2. Support 4 heating rods.3. 6 controllable fans, 2 normally open fans, and both support power supply voltage, 12V, 5V for selection.4. Adopt dedicated power chip, support 15-28V power input.5. Using high-performance MOSFET tube, better heat dissipation effect, reducing heat generation, so that the motherboard can work longer.6. Reserved dual Z-axis printer, two Z-axis motor interfaces, you can use the double Z kit to make the printer work more stable.7. Reserve WIFI interface.8. Thermistor leakage protection.9. Support to connect to Raspberry Pi.10. Support stall detectionmeters:Appearance size: 160 x 100 mmInstallation size: 150 x 90 mmMainboard input voltage: DC15-28VMotor input voltage: DC12-60V (select the appropriate voltage value according to the actual drive)Expanded interface function support: material interruption detection, continuous printing after power failure, shutdown after printing, BL Touch, etc.
BIGTREETECH Octopus Pro for CR10 Ender 3 3D printers Control Board Upgrade Motherboard Support Marlin 2.0 Klipper RRF TMC2209 TMC2130 A4988 TFT35 Screen LCD2004 ect (STM32F446ZET6)
£173.99
- 1. 【Added features】 Compared with Octopus, Octopus Pro’s new features are: 1. Support up to 60V stepper motor. 2. Support 3 kinds of firmware: Marlin 2.0, Klipper, RRF. 3. The onboard MAX31865 supports PT100/PT1000 temperature measurement and can perform higher temperature detection. 4. Support proximity sensor, jumper optional pull-up resistor, support more sensor models. 5. Level conversion converts the 3.3V signal is converted to 5V, which can improve the driving ability.
- 2. 【STM Master Chip】 The main control adopts 32-bit ARM-level Cortex-M4 series STM32F446ZET6 chip (180MHz, FLASH 512K)
- 3. 【Support up to 60V Driver】 The motor drive power supply can support 60V input (only for the motor drive power supply), to obtain a larger output power, not easy to lose steps, and the current reduction can reduce the heat generation.
- 4. 【Support high temperature printing】 The onboard MAX31865 can support 2/4-wire PT100/PT1000 temperature measurement without soldering (the welding resistance can support 3-wire PT100/PT1000 temperature measurement).
- 5. 【Extension ports】 The main board reserves SPI interface, UART interface and IIC interface can be used to expand the device.
In stock
Additional information
| Weight | 0.32 kg |
|---|---|
| brand | BIGTREETECH |
| dimensions | 18.8 x 12.8 x 4.2 cm; 320 Grams |