Octopus Pro Motherboard features:1. Each motor drive individually selects the power supply, the motor power supply or the main power supply (heater power supply).2. Support 4 heating rods.3. 6 controllable fans, 2 normally open fans, and both support power supply voltage, 12V, 5V for selection.4. Adopt dedicated power chip, support 15-28V power input.5. Using high-performance MOSFET tube, better heat dissipation effect, reducing heat generation, so that the motherboard can work longer.6. Reserved dual Z-axis printer, two Z-axis motor interfaces, you can use the double Z kit to make the printer work more stable.7. Reserve WIFI interface.8. Thermistor leakage protection.9. Support to connect to Raspberry Pi.10. Support stall detectionmeters:Appearance size: 160 x 100 mmInstallation size: 150 x 90 mmMainboard input voltage: DC15-28VMotor input voltage: DC12-60V (select the appropriate voltage value according to the actual drive)Expanded interface function support: material interruption detection, continuous printing after power failure, shutdown after printing, BL Touch, etc.
BIGTREETECH Octopus Pro Motherboard for Ender 3 CR10 3D printer Control Board Upgrade Support Marlin 2.0 Klipper RRF TMC2209 TMC2208 DRV8825 TFT35 Display 12864LCD ect (STM32F429ZGT6)
₪866.99
- 1. 【Added features】 Compared with Octopus, Octopus Pro’s new features are: 1. Support up to 60V stepper motor. 2. Support 3 kinds of firmware: Marlin 2.0, Klipper, RRF. 3. The onboard MAX31865 supports PT100/PT1000 temperature measurement and can perform higher temperature detection. 4. Support proximity sensor, jumper optional pull-up resistor, support more sensor models. 5. Level conversion converts the 3.3V signal is converted to 5V, which can improve the driving ability.
- 2. 【STM Master Chip】 The main control adopts 32-bit ARM-level Cortex-M4 series STM32F429ZGT6 chip (168MHz, FLASH 1024K). The STM32F429ZGT6 version of the Octopus Pro has 1024K flash memory, which can use all the functions of the RRF firmware. The STM32F446ZET6 version of the Octopus Pro has 512K flash memory, cuts some of the functions of the rarely used RRF firmware.
- 3. 【Support up to 60V Driver】 The motor drive power supply can support 60V input (only for the motor drive power supply), to obtain a larger output power, not easy to lose steps, and the current reduction can reduce the heat generation.
- 4. 【Support high temperature printing】 The onboard MAX31865 can support 2/4-wire PT100/PT1000 temperature measurement without soldering (the welding resistance can support 3-wire PT100/PT1000 temperature measurement).
- 5. 【Extension ports】 The main board reserves SPI interface, UART interface and IIC interface can be used to expand the device.
In stock
Additional information
| Weight | 0.33 kg |
|---|---|
| brand | BIGTREETECH |
| dimensions | 20.4 x 12.8 x 4.5 cm; 330 Grams |