Additional information
| Weight | 0.36 kg |
|---|---|
| brand | BIGTREETECH |
| dimensions | 20.9 x 11.6 x 7.9 cm; 360 Grams |
BIGTREETECH Octopus V1.1 for CR10 Ender 3 3D printer 32bit Control Board Upgrade Spider motherboard Marlin 2.0 Klipper Support TMC2209 TMC2208 TMC2130, TFT35 E3 V3.0, 1286LCD ect (with 8 TMC2209)
₪992.99
- 1. 【High-performance STM Master chip】The main control board adopts STM32F446ZET6 chip, ARM 32 bit Cortex-M4 CPU, the main frequency is up to 180MHz, 128KB SRAM + 512KB FLASH. The instruction manual and firmware: github/bigtreetech/BIGTREETECH-OCTOPUS-V1.0
- 2. 【Multi-function BIGTREETECH Octopus V1.1】Support 8 groups of stepper motor drives, 9 motor interfaces; 6 groups of controllable fans, 2 groups of normally open fans, and all support 24V, 12V, 5V options; 4 groups of heating rods; 6 groups of limit switches; 2 sets of material break detection. Support BLTouch, locked-rotor detection, shutdown after printing, resume printing after power failure, CAN bus, U disk function, IIC expansion.
- 3. 【Wide compatibility】Support Motor drive: pluggable drive, support STEP/DIR, UART, SPI 3 modes of driver. TMC2209, TMC2208, TMC5160, TMC2130 etc. Motor interface: MOTOR0, MOTOR1, MOTOR2_1, MOTOR2_2, MOTOR3, MOTOR4, MOTOR5, MOTOR6, MOTOR7. Support display screen: TFT35 E3 V3.0, TFT35 V3.0, TFT24, TFT43 TFT50 TFT70 V3.0, LCD2004, LCD12864. Support Marlin 2.0 and Klipper firmware.
- 4.【TMC2209 Driver】Avoid engine shaking. The motor is not easy to lose step, ultra-quiet mode. A large surface thermal pad, reduce the temperature of driving work. Support STEP / DIR and UART mode.
- 5.【Use the Driver】TMC Motor drivers can be used in SPI or UART mode by simply adjusting the onboard jumpers beneath each motor driver. Additionally you can connect or disconnect the TMC DIAG pin using an onboard jumper allowing you to use hard endstops or sensorless homing without the need to cut any pins.
In stock