BIGTREETECH SKR Pico V1.0 Motherboard Features: (1) Good looking. (2) With Raspberry Pi ARM Cortex-MO+ MCU RP2040. (3) Adopting a new design heat sink, better heat dissipation and appearance. (4) Chip Capacitors (MLCC) MURATA Capacitor (5) The fuse (holder + fuse) is easy to install and remove. (6) The TYPE-C interface is connected to the main control communication. (7) Introduction of Raspberry Pi with optimal size design. Parameters: Outer Size:85*56mm Installation size: see BTT SKR Pico V1.0-SIZE. Board layer: 4. Microcontroller: ARM Cortex-MO+RP2040 Power consumption: DC 12/24V Logic voltage: 3.3 V Motor driver: UART mode of integrated TMC2209 Motor Driver Interface:X, Y, Z1, Z2, E Temperature sensor interface: THO, THB, 2-way 100K-NTC (RTD) Communication with Raspberry Pi (Raspberry Pi): TYPE-C,UART. Note: 1. If you want to use a motor drive current of more than 0.8A, it is recommended to use a fan to actively cool the drive chip. 2. Do not remove the heat sink unless this is required. If it is to be removed, please make sure the heat-conducting silicone film is at the bottom of the heat sink during installation to avoid short circuit. 3. Wiring must be done when switched off. Please make sure the wiring is correct before switching on to avoid damage. 4. Please note that the jumper cap is inserted correctly. If you have any problems, please do not hesitate to contact us. We strive to provide you with the best quality products. If you have good comments or suggestions, please feel free to share them with us.
BIGTREETECH SKR Pico V1.0 Customised Control Board Motherboard
¥14,255
- INDUSTRIAL DESIGN – The BTT SKR Pico V1.0 adopts an industrial design for heat sinks, it makes the overall appearance of the motherboard full sense of technology, while the larger heat dissipation area makes calculating more efficient.
- Technical features: with Raspberry Pi ARM Cortex-MO+ MCU RP2040, chip capacitors (MLCC): Murata capacitor. The TYPE-C interface is connected to the main control communication. Easy installation and removal of the fuse (holder + fuse).
- Parameters: external size: 85 x 56 mm; installation size: please refer to BTT SKR Pico V1.0-SIZE; board layer: 4; MCU: ARM Cortex-MO+RP2040; power input: DC 12/24 V; logic voltage: 3.3 V; motor driver: UART mode of the on-board TMC2209; Motor driver interface: X,Y,Z1,Z2,E; Temperature sensor interface: THO,THB,2-way 100K NTC(RTD); Communication with Raspberry Pi (Raspberry Pi): TYPE-C,UART.
- Technical support: please send us a message via Amazon message if you encounter a problem. We have a professional technical team that supports you.
- Caution: Please use a fan to actively cool the driver chip with a motor driver current of more than 0.8A. Please complete the wiring with the device turned off. Please make sure the wiring is correct before turning on. Please note that the jumper cap is inserted correctly. Remove the heat sink only if required.
In stock
Additional information
| Weight | 0.13 kg |
|---|---|
| brand | BIGTREETECH |
| dimensions | 11.7 x 7 x 3.9 cm; 130 Grams |