Cavabien 3D Resin Printer Platform 202X128mm Magnetic Plate Steel for Anycubic Mono X Anycubic Photon X Smart Kumitsu KL9 SLA 3D Printers

Cavabien 3D Resin Printer Platform 202X128mm Magnetic Plate Steel for Anycubic Mono X Anycubic Photon X Smart Kumitsu KL9 SLA 3D Printers Please do check the steps in our descriptions carefully before making it work. Please be careful when touching the edge of the steel plate to avoid being scratched. Specifications: Size: 202X128mm. (7.95×5.04 inch) Steel plate thickness: 0.4mm. Works with Anycubic Mono X, Anycubic Photon X, Smart Kumitsu KL9 3D Printers. Installation steps: 1. Clean your build plate with isopropyl alcohol and keep it DRY so that the magnet can work normally. Clean the flexible steel plate too with wet paper if necessary. If the room temp in your city is below 10 0C, the print model will be hard to stick to the base, please heat the magnetic base a while before installing. 2. Check the best position to place the magnetic base to your build plate in case it will be shifted. Please tear off the 3M adhesive about 20mm at first and then install step by step completely. You can press it back and forth to make sure there is no gap or bubble. 3. Wait 48-72 hours so that it can work better. 4. Place the flexible steel plate on the magnetic base and make sure the handle faces you. 5. You may need to adjust the z limit switch after installation. (not all printers need to adjust) It should be around 2.5mm higher. That means the printing height will be reduced about 2.5mm. You can print a spacer or nut to fill the difference. 6. Level your build plate so that it can work and print. Package includes 1x flexible Steel Plate and 1x magnetic base sticker with strong adhesive.