Central Heating System Inhibitor (500ML) Treats 100L System C100

YSTEM INHIBITOR Inhibits corrosion, scale, hydrogen gassing, microbiological growth and boiler noise. For best results systems should first be cleansed and then flushed with C300 in accordance with BS7593:2006. FILLING THE SYSTEM: Open systems should be closed via F&E cistern (adequate draining from low point is recommended to ensure that all the C100 enters the circulating part of the system). Sealed systems: C100 should be injected into the filling loop or other access point. If the system is empty, pour C100 into any convenient point prior to filling. CLEANING: circulate C300, with all the valves open, for at least an hour. Warming the water will assist the process. Flush the system and then drain off at all drain points. Systems should be flushed in accordance with the manufacturer’s recommendation. When refilling the system use C100 inhibitor. Dosing Rate: C100 should be dosed at 1% of system volume – ie: 25L of C100 per 2,500 litres of the system’s water. For new systems, C100 should be added at the time it is first filled. Generally, one of our small bottles contains enough for an average central heating system. For larger systems use a larger version C100 – over-dosing will not cause any detrimental effects to the system. Please note: where a thermal storage appliance is fitted, allowance must be made for the increased volume of primary water. The concentration may be checked with a conductivity meter. CAUTION: C100 MUST BE LEFT IN THE SYSTEM. DO NOT ADD TO PRIMATIC SYSTEM. HEALTH & SAFETY: Low hazard product – safe in normal use. Wear gloves, wash splashes off skin with soap and water. If the product enters eyes wash immediately with large amounts of cold water. Keep out of the reach of children. Do not ingest. Some people are more sensitive to chemical products than others. If irritation occurs, discontinue use. Always follow manufacturer’s recommendations when using this product.