Challenge SU thermoplastic housed bearings are available in the following configurations: pillow blocks (SUCP2.); 2-hole flange units (SUCFL2.); and 4-hole flange units (SUCF2.). Choice is very much determined by the requirements of the application, although aesthetic appearance of the machine design is often an important consideration. The bearings and nipples are made from stainless steel. End caps are supplied with each unit. Challenge thermoplastic bearing units have been designed to meet more demanding environments such as the food and chemical industries, where frequent wash downs are necessary, optimum hygiene standards are required and good chemical resistance is important over a wide temperature range. The shaft locking arrangement consists of two knurled cup-point, self-locking, socket-head set screws fitted in the extended inner ring. For normal loads and moderate speeds simply mount the bearing unit into position and tighten down the set screws to the recommended torque value. Challenge bearing units accommodate initial housing misalignment up to 0,030 radians but are not recommended for running misalignment in excess of 0,001 radians.
Challenge SUCF208 Thermoplastic 4-hole Flange Unit with Stainless Steel Bearing and End Cap
CAD $31.99
- Thermoplastic Housing with Stainless Steel Bearing
- Sealed units for longer life
- Supplied with end cap and grease nipple
- Self-aligning
- Fully interchangeable with other brands
In stock
Additional information
| Weight | 0.96 kg |
|---|---|
| brand | Challenge |
| dimensions | 13.72 x 13.46 x 9.14 cm; 960 Grams |