NOTE1ware selection When using the UART working mode, carefully use the soldering iron to prevent burns, handle After observing, carefully observe whether the module has residual tin slag. It must be cleaned to prevent ite the module to be short-circuited and burned;2. Pay attention to the line sequence and IO port when wiring. Connecting the wrong line will directly cause the driver to not work. 3When plugging the driver into the motherboard, pay attention to see the driving direction, do not insert the wrong direction, and prevent the drive was burned.4 sure to do the heat dissipation work (heat sink + cooling fan) before driving to prevent driving not working properlyIf you encounter other problems in use, please contact us, we will be careful answer for you; if you have any good comments or suggestions on our products, you are welcome to return tell us, we will carefully consider your comments or suggestions, thank you for choosing kingprint products, thank you!Packaging includes:4 x TMC2208 V2.1.4 x heat sink.
Kingprint TMC2208 V3.0 Stepper Damper with Heat Sink Driver, Replacement Damper for A4988 DRV8825 for 3D Printer (5 pieces)
₹6,960
- TMC2208 V2.1 motor current can be arbitrarily set by firmware
- Microsteps can be set arbitrarily by firmware (up to 256 actual microsteps)
- Combine actual and interpolated microsteps for maximum torque
- Compared with TMC2208 V2.0, V2.1 adopts the high quality flat gold finish,which is more stable,has strong oxidation resistance and better heat dissipation.
- When the motor is not moving, the motor standby current can be dynamically reduced (via UART)
In stock