has all the items you need to help your lay down laminate flooring or vinyl plank flooring.
Package List：
1 x Double Headed Hammer:
Material: Fiberglass & Rubber
Head Size: 8.5cm
Diameter: 3cm
Handle Size: 27cm
1 x Flooring Installation Pull Bar
Material: Manganese Steel
Length: 30cm
Width: 7.2cm
1 x PC Plastic Tapping Block
Material: PC
Length: 17.5cm
Width: 6.5cm
40 x Flooring Wedge Spacers
Material: Plastic
Length: 6cm
Width: 3cm
1 Pair x Protective Foam Knee Pads
How to use this floor installation kit?
Step 1. Spacers are used between the wall and the flooring to allow for natural expansion of wood products. The spacers have “serrated” edges that lock them into the correct position once a board is placed against them.
Step 2. Start by placing the long edge of tapping block against flooring. With a hammer, gently tap the other long edge of the tapping block to push the flooring together to form a tight fit. It can be used with both adhered and glue less laminate or hardwood floating flooring systems.
Step 3. Place the short end of the pull bar down so the lip hangs down over the end of the flooring panel With the tall end pointing up use a hammer and gently tap the tall section pulling the flooring together.
Note:
It is recommended that you have to be careful that the tapping block is always flat on the floor so the groove of your plank is within the groove on the block so as not to damage it.
Applicable to composite floor like vinyl plank flooring. Not applicable to all plastic floor.