Petyoung Brine Shrimp Eggs Hatcher Incubator Hatchery Artemia Eggs Hatchery Kit DIY Aquarium Fish Tank Hatch Tool

SpecificationMaterial: PlasticHeight: 27.5cm / 10.83inOuter diameter: 5cm / 1.97inThickness: 0.2cm / 0.08inPrecaution:1. Inject the treated water into the standard water level line of the incubator tank, and add about 10g of coarse salt to dissolve in advance.2. Connect the air pump to the air inlet hole at the bottom of the incubator, adjust the air volume to an appropriate amount. The ideal temperature is 28-30°C.3. Re-inject approximately 3 to 5g of brine shrimp eggs and incubate for about 36 to 48 hours (depending on the incubation temperature and the quality of the shrimp eggs).4. Collection operation: After hatching of the brine shrimp eggs, stop pumping and let stand for about 10 to 15 minutes. When the hatched shrimps sink to the bottom and the shrimp shells float up, you can collect shrimp larvae from the original air inlet at the bottom of the incubator (air conditioning valve).5. Uneaten brine shrimp larvae should be stored in the refrigerator to freeze.6se adjust the input gas volume. If the input gas volume is too large or too small, it will affect the hatching time and survival rate of the brine shrimp eggs. Please adjust the input gas volume with the air conditioning switch.7. The bottom air supply port is connected with a simple check valve, which can effectively prevent water backflow in the incubator. 8. It can also be installed in an aquarium and hatched at a constant temperature in the aquarium.9. Please allow 1-3cm error due to manual measurement and make sure you do not mind before orderingage Including1* Brine Shrimp Eggs Incubator1* Lid