This stepper motor controller board , compared to the last edition, features the ability to generate a PWM signal. Comes with a jumper, you are able to change the the default frequency pulse signal to PWM pulse signal. The motion and reversing of the motor can be controlled by pressing the key. The speed of the motor can be controlled by adjusting the frequency of the potentiometer. Specification: Power supply voltage: 15-160V / 5-12V Frequency: High: 5.8KHZ-127KHZ, Mid: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZ Size: Approx. 73 x 51 x 37mm / 2.87 x 2 x 1.45inch Weight: 50g Quantity: 1pc Package List: 1 x PWM GeneratorNote: If you use to start or stop the function, ENA controller enable terminal must be connected to common cathode or common anode drive.
PWM/Frequency Pulse Signal Generator Module Adjustable Stepper Motor Drive Controller Board with Jumper for Simple Speed and Reversing Regulation
₪148.99
- Make sure this fits by entering your model number.
- This module is supplied as a stepper drive signal. To control the stepper motor, also must have the drive to use
- The controller has high, medium and low total of three types of frequency signals can be used to select jumper
- Frequency of measurement can amount PUL and common cathode terminal (GND) two ports
- PUL + and PUL- pulsed positive and negative; EN + and EN- enable the positive and negative terminals; DIR + and DIR- positive and negative directions, six lines connected to drive the corresponding pulse, direction, so 6 ports possible
- Power supply: 15-160VDC or 5-12VDC. If you are using 5-12VDC power, positive end connect DC 5-12V Input, negative end connect Common Cathode End.
In stock
Additional information
| Weight | 0.12 kg |
|---|---|
| brand | Walfront |
| dimensions | 12 x 9 x 3 cm; 50 Grams |