With use, the rubber button that activates the power button of the device, breaks and breaks. With the broken button, you cannot turn on the device, and if an element is introduced into the hole to operate the button, it will most likely end up damaging such a button, and the failure will greatly aggravate.
The button that activates the button is an integral part of the case and the ideal solution, would be to replace the entire case; but unfortunately GARMIN does not provide replacement housings for your devices, so to give a solution, our technicians have designed a custom button that allows you to operate the button without damaging it and then repair the device.
The button is white to fit discreetly into the case of the device. It has been designed very precisely and is made with a high definition 3D printing system.
To repair your device follow these simple instructions: Cut out the remnants of the original button to profile the opening. Cleans and degreases the area with alcohol. Apply a thin layer of B6000 or B7000 contact glue to the device and also to the button and allow to dry for a few minutes. Place the button in place and press with your fingers so that it is well adjusted. Clean the adhesive residue and you’re done.
Twowinds Ignition Button Compatible with Garmin Edge 1000 GPS, Cyclocomputer Ignition Button (Set of 2) Black
₹3,698
- Button that activates the power button of the device, start button for the on/off switch of the bicycle computer.
- Compatible with Garmin Edge 1000 GPS
- Perfect for replacing the original rubber button that breaks with use.
- Contents: two black power buttons.
- QUICK AND EASY INSTALLATION: Install on top of device in the upper right corner. Remove the defective button with a toothpick, clean the surface, apply a small amount of multi-purpose adhesive (not included) to the back of the new button, place the new button by pressing hard for a few seconds and let it dry for 24 hours.
In stock
Additional information
| Weight | 0.002 kg |
|---|---|
| Brand | Twowinds |